FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the F
10 Step 7. The Repeater will automatically pre-configure itself with default information and then reboot. If there are multiple wireless networks or
11 Advanced Configuration Advanced configuration options for the Repeater can be accessed via the web interface. Step 1. Connect an RJ45 Ethernet cab
12 Wireless Click the link for ‘Wireless’ on the main menu, followed by ‘Basic Settings’. This will present the basic wireless configuration options
13
14
15
16 LAN Interface The ‘LAN Interface’ options allow for configuration of settings for the LAN port (RJ45), when used in Access Point mode. The Unit’s
17
18 Save/Reload Settings The current settings for the unit can be saved to a file on your computer and reloaded onto the Repeater at any time. The Rep
1 Table of Contents INTRODUCTION ... 2 PACKAGING CO
19 Specifications Supported Wireless Standards IEEE 802.11b/g/n Chipset ID Realtek RTL8196C Connectors 1 x RJ45 Ethernet female LEDs 1 x Power 1 x
20 Technical Support HooToo’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever nee
2 Introduction The HT-WR01 300Mbps Wireless-N WiFi Access Point and Repeater has two selectable modes for extending the range of existing wireless ne
3 Diagram Front Power Wireless Link/Activity Ethernet Link/Activity WPS Reset Button RJ45 Ethernet Port
4 Installation Repeater Mode Setup: Step 1. Connect the Repeater to an available AC electrical outlet. Step 2. Two Options: a. Wired Setup: Connect a
5 are ‘admin’ (without quotes). Step 5. From the main menu on the left side of the web interface, click the ‘Setup Wizard’ link followed by the ‘Wire
6 Step 8. Wireless encryption settings will be automatically detected and listed on the following screen. If the wireless network has a password, th
7 Step 9. After the unit has rebooted, the configuration settings/status will be listed. Confirm that the Mode has been set and the correct network
8 Access Point Mode Setup: Step 1. Connect the Repeater to an available AC electrical outlet. Step 2. Two Options: a. Wired Setup: Connect an RJ45 Et
Comments to this Manuals